This neat little plug designed and produced by MiSTer Addons allows you to connect the Digital IO board and DE10-Nano DC power sockets together. The DC jumper is only used with the Digital IO board or BlisSTer board.
To use the built in Digital IO board power switch, simply link your power supply to the DC power socket on the Digital IO board. Next, connect the ends of the DC Power Jumper to the DE10-Nano’s DC power socket, and the USB Hub’s DC power socket. With this setup, you can conveniently manage power for the whole MiSTer stack using the on/off switch located on the Digital IO board.
✅ For Digital IO & BlisSTer Board Only
✅ Minimise Cable Clutter
✅ High Quality Connectors
✅ Male To Male DC Power Plugs
DC Power Jumper Compatibility:
✅ Terasic DE10-Nano
❌ Retro Remake MiSTer Pi
❌ QMTECH Cyclone V
| Option1 | Option1 |
|---|
Be the first to review “MiSTer FPGA DC Power Jumper”
Related products
Accessories
If you are looking for the best, this is a high quality power supply for your MiSTer FPGA setup, you need look no further as this is possibly the ultimate MiSTer power supply providing clean power at 5 volts and up to 4 amps, plenty of overhead for any additional power requirements. Mean Well are [...]
Accessories
A two meter long mains cable with IEC C7 (figure of 8) connector and a selection of interchangeable country specific plug heads, this is designed to allow electricity to flow from point A to point B 🙂 Perfect for use with this high quality MiSTer DE10-Nano power supply. ✅ 2 Meter Long Cable ✅ UK [...]
Cooling
A minimal cost effective active cooling solution for your MiSTer build, if you do not require an IO Board but still wish to adequately cool the ARM / FPGA chip this is the perfect solution a super quiet fan, mounted on a solid aluminium heatsink. Installation is simple just remove the film from the thermal [...]
When using a SNAC adapter with the MiSTer to avoid any strain on the User IO port, the recommended connection setup is to use a short male to female USB 3.0 extension cable between the SNAC adapter and the User Port on the MiSTer IO board. This high quality USB 3.0 extension has a shielded [...]
Accessories
Perfect for connecting your MiSTer setup to a USB hub or BlisSTer board, the USB bridge connector offers a clean solution via two short Micro USB connectors, one plugs into the DE10-Nano’s Micro USB socket and the other plugs into the Micro USB socket on the BlisSTer board or official MiSTer USB Hub. ✅ Suitable [...]
Accessories
When connecting the Raspberry Pi based MT32-Pi to the MiSTer via a USB 3.0 A-to-A cable, it’s important to use a short cable to ensure stable performance, this MT32-Pi USB 3.0 cable is the perfect choice. Since I²C is not intended for long-distance transmission, longer cables can cause degradation due to capacitance or signal reflections. [...]
Accessories
If your MiSTer USB Hub has a Micro USB socket installed, and you wish to streamline your MiSTer setup, this bridge connection offers a neat solution via two long Micro USB connectors, one plugs into the DE10-Nano boards Micro USB socket and the other plugs in the Micro USB socket on your MiSTer USB Hub [...]
Accessories
A one meter long mains cable featuring an IEC C13 connector on one end and an 3 pin UK moulded plug on the other. This power lead transfers mains power from a UK mains socket to a device with an IEC inlet. Designed for use with IEC C14 devices such as the high quality MiSTer [...]
Reviews
There are no reviews yet.