A compact USB WiFi dongle perfect for use with the MiSTer FPGA.
Firstly plug the WiFi adapter into a USB port, then to configure the WiFi adapter just run the script wifi.sh either from the Menu core on the MiSTer FPGA or via SSH. Reboot the MiSTer once WiFi network configuration has been completed. If configuration has been successful once the MiSTer has rebooted the Menu core will display a WiFi icon to show WiFi is connected.
Manual WiFi configuration can be completed by following the steps documented in the MiSTer Wiki.
✅ Compatible With MiSTer FPGA
✅ USB 2.0 Interface
✅ Data Rate Up To 300Mbps
✅ IEEE 802.11 b/g/n Standards
| Option1 | Option1 |
|---|
Be the first to review “MiSTer FPGA WiFi Adapter”
Related products
Accessories
Building a custom case to house your MiSTer? If you need to add external push buttons and LEDs this pair of extension leads allows you to remotely mount buttons and LEDs. The pair of leads connect to the 5 pin and 7 pin header sockets on MiSTer Digital and Analog IO boards. The circuit diagrams [...]
Accessories
When using a SNAC adapter with the MiSTer to avoid any strain on the User IO port, the recommended connection setup is to use a short male to female USB 3.0 extension cable between the SNAC adapter and the User Port on the MiSTer IO board. This high quality USB 3.0 extension has a shielded [...]
Accessories
A male DC jack to male DC jack jumper cable, this is perfect for use with a MiSTer Digital IO board allowing for powering of the USB Hub directly from the DE10-Nano. If you are using the Digital I/O MiSTer addon board just connect your DE10-Nano power supply into the Digital IO boards DC power [...]
Accessories
If you are using the high-quality MiSTer Mean Well power supply or any other power supply with a DC barrel plug, this adapter cable allows you to connect it to the MiSTer Pi’s USB-C power input socket. Simply plug the USB-C end into the MiSTer Pi’s power input, and then connect the female DC socket [...]
When using a SNAC adapter with the MiSTer to avoid any strain on the User IO port, the recommended connection setup is to use a short male to female USB 3.0 extension cable between the SNAC adapter and the User Port on the MiSTer IO board. This high quality USB 3.0 extension has a shielded [...]
Accessories
Perfect for connecting your MiSTer setup to a USB hub or BlisSTer board, the USB bridge connector offers a clean solution via two short Micro USB connectors, one plugs into the DE10-Nano’s Micro USB socket and the other plugs into the Micro USB socket on the BlisSTer board or official MiSTer USB Hub. ✅ Suitable [...]
Accessories
When connecting the Raspberry Pi based MT32-Pi to the MiSTer via a USB 3.0 A-to-A cable, it’s important to use a short cable to ensure stable performance, this MT32-Pi USB 3.0 cable is the perfect choice. Since I²C is not intended for long-distance transmission, longer cables can cause degradation due to capacitance or signal reflections. [...]
Accessories
If you are looking for the best, this is a high quality power supply for your MiSTer FPGA setup, you need look no further as this is possibly the ultimate MiSTer power supply providing clean power at 5 volts and up to 4 amps, plenty of overhead for any additional power requirements. Mean Well are [...]
Reviews
There are no reviews yet.